Originally posted by doc.mark.dimo So you basically affix the silicon cone and not the pole of the button back onto the camera? I have both my buttons, and I was afraid super glue may leak down the travel path of the spring that must be depressed. hmmm, seems like a simple pin or fastener wore off and released the buttone. does anyone have a diagram of what the original assembly is supposed to look like??
Mark
If you place a very small dot of glue on the tip and wait 5 seconds it won't leak. If you're concerned about the amount, you can practice by applying the glue and pressing it against an ice-cream container lid(super glue doesn't stick to this material) and see how much the tip can hold before squishing off.
PS. you can clean off the glue using finger nail polish remover when you're done.
Hope this helps.