Staff note: This post may contain affiliate links, which means Pentax Forums may earn a small commission if a visitor clicks through and makes a purchase. If you would like to support the forum directly, you may also make a donation here.
so after a bit of searching and annoyance at how easily this part is lost, i found a forum member with lots of 3d printing experience. he has been VERY kind as far as mocking up a 3d printer file in his spare time, still a bit of work to go, but this is essentially where its at
need to take some measurements of the dial without the cap etc. but this was done from the measurements provided in another thread on here.
with any luck a cheap replacement will be printable soon!