Originally posted by el baroda Hi. Thanks for your input but Canon is not in the list of codes.
You're out of luck, then,
If you can get it to do this (taken from Calsan's link), great:
"The remote control generates a series of IR pulses as shown below. The 'on'-
pulses are modulated at 38kHz.
||||||||||||| ||| ||| ||| ||| ||| ||| |||
38kHz ---> ||||||||||||| ||| ||| ||| ||| ||| ||| |||
modulation _|||||||||||||_________|||___|||___|||___|||___|||___|||___|||_
duration [ms] | 13 | 3 |1| 1 |1| 1 |1| 1 |1| 1 |1| 1 |1| 1 |1|
This waveform is approximated in the Palm device by setting the baud rate to
38000 and sending sequences of characters of all ones or all zeros to the IR
UART. The end result is not exactly the same, but it seems to work fine."
If your remote can learn IR, borrow a friend's Canon remote (for their lower end models) to teach it the sequence.