Originally posted by gilbej49 I am doing a firmware update for my K7. I followed the readme file, downloaded to my descktop and then copied only firmware, not readme file to SD card. Inserted into camera, held down menu button while turning on camera. It display fireware 1.03 I clicked on yes to update, it is showing Updating and underneith that it says PHASE 1/2 and a white box under that. The Readme file said it should only take 90 sec. to complete. It has been in the state I just mentioned for at least five to ten minutes. What did I do wrong?
I've read of this happening before but can't remember exactly where. You might also want to ask your question
here. I don't want to make any suggestions that will turn your camera into an expensive brick so I cannot help you further than that.
You Did make sure your battery was charged? FWIW, I've never emptied a card, just put the BIN file in the root directory and it's worked every time. I mention that in case you are thinking that may be the problem. I must admit that for the 90 seconds, I'm holding my breath. There HAVE been times where there seemed a long delay between phase one and phase two to begin.
?