Forum: Troubleshooting and Beginner Help
12-12-2016, 12:46 PM
|
|
Thank you both for responding. As I stated, for the past 4 to five weeks, the camera would not go to auto ISO when in TAv. I would have to adjust ISO manually. Like it was set to manual by the knob, which I could do. It wasn't until yesterday that the camera locked into manual mode, (as if I did it by setting dial to M). No matter what position i turn the dial to, the camera stays in manual. This happened when I pressed the ISO button on top of the camera, released it, then pushed the green button above the four way selector switch on the back panel. It may well be that I have two or more problems.
It looks like I might have to send it in for repairs. Should I go through the store I bought it from, or would it be quicker to send it straight to the repair center myself?
Once again, thank you for your assistance. It is greatly appreciated.
Charlie
|
Forum: Troubleshooting and Beginner Help
12-11-2016, 06:33 PM
|
|
Greetings All,
I have a K1 that I have owned since April that has worked properly until recently. For the last month, the camera won't go into auto ISO when shooting in TAv. Today while reading the instruction manual I noticed it said to press the ISO button on top of the camera, then press the green button above the four way to put it in auto-focus. After doing this, the camera went into manual mode and i can"t get it out no matter which switches i move. I have also removed the battery several times. Has anybody had this same issue? I have updated to the most recent firmware.
Thank you,
Charlie
|