|
Forum: Troubleshooting and Beginner Help
08-13-2015, 02:22 PM
|
| |
Thanks a lot for that detailed list Jatrax; it's much appreciated.
I already have dust removal enabled on StartUp - so point one is ticked off.
I don't have a rocket blower, but one's ordered - so point two ticked off, too.
And hopefully that will get me through this. Thanks again for your advice.
---------- Post added 08-13-15 at 02:24 PM ----------
I did see a lot of Canons so one of these snakes must have jumped. Will keep further away from them in future!
---------- Post added 08-13-15 at 02:25 PM ----------
And that's what I thought too!
|
|
Forum: Troubleshooting and Beginner Help
08-13-2015, 12:19 PM
|
| |
Thanks guys. On-board dust removal is enabled but hasn't shifted it. I'll pick up and dust-blower and see if that does the trick.
|
|
Forum: Troubleshooting and Beginner Help
08-13-2015, 11:47 AM
|
| |
Hi guys - I'm an inexperienced K-30 user (though I longer used an ME Super). I seem to have acquired some weird lines on my images (there's one in the centre and two on the bottom right-hand corner). I have no way of knowing what caused this (though I was at an agricultural show today and did change lenses on a number of occasions). I have the dust removal option turned on to run on start-up. It certainly doesn't look like dust-spots. I have run it on multiple occasions since I spotted the problem and it hasn't helped. Might be small hairs, but seem too transparent. I haven't tried to clean the sensor manually as I wouldn't feel able to do that. Any thought from an experienced users would be appreciated.
|
