|
Forum: Film Processing, Scanning, and Darkroom
08-09-2017, 01:47 PM
|
| |
I have done color in the past. Temperature is a consideration, but not as complicated as you might think. I would take the pint bottles of chemistry (about 6 I think) and float/place them in a bath of water at the required temperature. Using a thermometer (accurate one), I would get the water coming out of the tap the proper temperature, or just a bit under, and then once the container was filled I would use a simple fish tank heater to bring the temp up to the proper level. This would take the most time. Don't over shoot. Bring the temp up slowly as it is faster to heat the bath than to get it to cool down. Once the chemistry is at the proper temp you can start processing the film. TO maintain temps through the process, it tool like The Lab can be place in a water bath also (just don't go too high!)
Regards,
|
|
Forum: Film Processing, Scanning, and Darkroom
05-15-2017, 01:26 PM
|
| |
What was old is new again!
|
|
Forum: Film Processing, Scanning, and Darkroom
03-03-2017, 09:41 AM
|
| |
OK, you still need the chemicals, but this IS a great product! Why did it take until the digital age to come up with it!
I wold interested in a review of the single develop/fix chemistry to understand how permanent the process would be.
Film is ALIVE!!!!
|
